Overview
The TwinflexPro² 604‑0008 boxed contractor kit is an 8‑zone two‑wire conventional fire alarm solution built around Twinflex Multipoint ASD detectors and the TwinflexPro² control panel. The system supports detectors, manual call points and sounders on a single two‑wire zone circuit to reduce installation time and cable runs.

• Two‑wire (single pair) zone wiring supporting detectors, sounders and call points on the same circuit
• Alarm confirmation / checkpoint technology for programmable pre‑alarm verification
• 4×20 character backlit LCD with highlighted menu navigation and an event log of up to 500 events
• Multipoint detectors with 7 selectable detection modes (3 smoke, 2 heat, rate‑of‑rise, combined smoke/heat)
• RS‑485 interface for up to 8 repeater panels

What’s included

• 1 × TwinflexPro² 8‑zone control panel (panel model referenced as 505‑0008)
• 7 × Twinflex Multipoint ASD detectors with integral sounder
• 2 × Twinflex manual call points
• 1 × detector head removal tool
• Note: panel requires 2 × 12 V sealed lead acid backup batteries (commonly 3.2–3.3 Ah) which are not always supplied with boxed kits

Use cases
Ideal for domestic, multi‑dwelling or small commercial communal installations where reduced wiring and clear alarm verification routines are beneficial. Suitable for contractors and installers seeking a compact 8‑zone boxed solution with integral logging and repeater capability.

Compliance & installation
Refer to the official Fike TwinflexPro² datasheet and installation manual for region‑specific certifications, EN54/CPR/UKCA markings and full wiring/commissioning instructions. Installation must be carried out by competent, certified personnel in accordance with local fire safety regulations and BS/EN standards where applicable.