MoTeC PDM15 Motorsport Wiring Loom

Motorsport-grade ETFE (MIL-W-22759/16) wiring loom engineered specifically for the MoTeC PDM15 Power Distribution Module.

This wiring loom is designed for builders who require a reliable, professional-grade electrical foundation for a MoTeC PDM15–based power distribution system. Hand-built using MIL-W-22759/16 motorsport-grade ETFE wire, it is intended for high-performance and motorsport applications where heat, vibration, electrical noise, and long-term durability are critical.

Whether you’re completing a ground-up race build, an engine conversion, or a high-end street car, this loom removes the compromises commonly found in universal or automotive-grade wiring.

Designed Specifically for MoTeC PDM15

This loom is pinned exclusively for the MoTeC PDM15. Every circuit is allocated correctly for the PDM’s power inputs, switched outputs, control signals, and CAN communications — with no universal pinouts, repurposed circuits, or guesswork.

The result is a clean, predictable wiring system that supports reliable power distribution, stable CAN communication, and consistent long-term electrical performance in demanding environments.

Built Using Motorsport-Grade ETFE Wire (MIL-W-22759/16)

MIL-W-22759/16 ETFE wire was originally developed for aerospace and military applications and is ideally suited to harsh motorsport environments.

Key benefits include:

• Excellent resistance to heat, fuels, oils, and automotive chemicals

• Thin, lightweight insulation for compact, low-bulk looms

• High durability under vibration and continual movement

• Reduced risk of insulation degradation over time

This wire is selected for reliability — not cost.

Unterminated Configuration (Flying Leads)

This MoTeC PDM15 loom is supplied in an unterminated (flying lead) configuration as standard, allowing complete flexibility for system layout, circuit allocation, and vehicle-specific routing.

A pin placement sheet showing wire numbers is available to download to assist with installation.

Custom terminations, wire lengths, and additional circuit provisions can be discussed prior to ordering if required.

Suitable Applications

This loom is suitable for:

• Motorsport builds (circuit, drag, time attack)

• Engine swaps and custom conversions

• Vehicles using standalone PDM-based power systems

• Professional workshops and motorsport fabricators

This is not a vehicle-specific plug-and-play harness. It is intended for custom installations where control, reliability, and electrical integrity matter.

What’s Included

• MoTeC PDM15 connector(s)

• Pre-wired ETFE (MIL-W-22759/16) wiring loom

• Built to order and quality checked prior to dispatch

Fuses, loads, ECUs, sensors, actuators, and the PDM15 module are not included.

Lead Time

Each loom is hand-built to order. Typical lead time is displayed at checkout and may vary during busy periods.

If your build has a deadline, please contact us prior to ordering.

Built to Support Compact PDM-Based Systems

The MoTeC PDM15 is a compact, professional motorsport-grade power distribution module suited to streamlined builds and auxiliary power management. This loom is designed to support it properly — without shortcuts, compromises, or unnecessary complexity — while maintaining professional motorsport wiring standards.

Select options above or contact us to discuss custom requirements.

Legal Notice

MoTeC® is a registered trademark of MoTeC Pty Ltd. This product is not affiliated with or endorsed by MoTeC.